![]() You’ll find detailed information on configuring and using rclone in the Linux Photography book. Since you are configuring rclone on a headless machine, follow the instructions on the Remote Setup page. Once you’ve done that, run the rclone config command. ![]() Sudo cp rclone.1 /usr/local/share/man/man1/ ![]() On your Linux machine, open the terminal and connect to the device using the ssh command.ĭeploying rclone then is a matter of running the following commands: Switch then to the Admin section and enable SSH access. Switch to the Wi-Fi section, and connect to the existing your local Wi-Fi network. Open a browser, point it to, and log in to the device’s web interface. To connect the WD My Passport Wireless to you current Wi-Fi network, power the device and connect to the wireless hotspot it creates from your regular Linux machine. Deploy, for example, rclone on the device, and you can back up the photos and raw files stored on the disk to any supported cloud storage service.īefore you can do this, though, you need to connect the device to a Wi-Fi network and enable SSH (so that you can access the underlying Linux system via SSH). While WD My Passport Wireless is a rather useful device in its own right, the fact that it powered by a lightweight yet complete Linux distribution means that its capabilities can be extended even further.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |